Interior Lighting System DTCS: BCM
| DTC | Description | Action |
|---|---|---|
| B1175:01 | Drivers Door Ajar Switch: General Electrical Failure | If all courtesy lamps are inopertive, GO to Pinpoint Test A . If all courtesy lamps are always on, GO to Pinpoint Test E . |
| B1176:01 | Passenger Door Ajar Switch: General Electrical Failure | If all courtesy lamps are inopertive, GO to Pinpoint Test A . If all courtesy lamps are always on, GO to Pinpoint Test E . |
| B11C0:01 | Driver Side Rear Door Ajar Switch: General Electrical Failure | If all courtesy lamps are inopertive, GO to Pinpoint Test A . If all courtesy lamps are always on, GO to Pinpoint Test E . |
| B11C1:01 | Passenger Side Rear Door Ajar Switch: General Electrical Failure | If all courtesy lamps are inopertive, GO to Pinpoint Test A . If all courtesy lamps are always on, GO to Pinpoint Test E . |
| B12C2:11 | Puddle Lamp: Circuit Short To Ground | GO to Pinpoint Test D . |
| B12C2:15 | Puddle Lamp: Circuit Short To Battery or Open | If the puddle lamps are inopertive, GO to Pinpoint Test D . If the puddle lamps are always on, GO to Pinpoint Test G . |
| B1306:01 | Liftgate Ajar Switch: General Electrical Failure |
NOTE:
The BCM opens the liftgate during theBCM self-test causing DTC 1306:01 to set. This DTC should only be diagnosed if there is a symptom. If all courtesy lamps are inopertive, GO to Pinpoint Test B
. If all courtesy lamps are always on, GO to Pinpoint Test E
. |
| B1313:11 | Interior Lighting Output: Circuit Short To Ground | GO to Pinpoint Test C . |
| B1313:15 | Interior Lighting Output: Circuit Short To Battery or Open | If the interior courtesy lamps are inopertive, GO to Pinpoint Test C . If the interior courtesy lamps are always on, GO to Pinpoint Test F . |
| U1000:00 | Solid State Driver Protection Active-Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, . |
| All other DTCs | - | REFER to the DTC Chart in Multifunction Electronic Modules . |