DTC C1B00: Steering Angle Sensor

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2018 Lincoln MKZ, 2018 Ford Transit-350 HD, 2018 Ford Transit-350, 2018 Ford Transit-250, and 2018 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

Failure	Action
09	This DTC sets if the SASM has an internal failure. CARRY OUT the SASM Module Reset function. CYCLE the ignition from ON to OFF and back to ON. DRIVE the vehicle and carry out at least 1 right turn and 1 left turn. CARRY OUT the SASM self-test. If the DTC does not return, the repair is complete. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article
29	This DTC sets if the information received from the SASM does not agree with other inputs. CARRY OUT the Adaptive Steering Wheel Angle Sensor Trim function. CYCLE the ignition from ON to OFF and back to ON. DRIVE the vehicle and CARRY OUT at least 1 right turn and 1 left turn. CARRY OUT the SCCM self-test. If the DTC does not return, the repair is complete. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article

Failure

Action

This DTC sets if the SASM has an internal failure. CARRY OUT the SASM Module Reset function. CYCLE the ignition from ON to OFF and back to ON. DRIVE the vehicle and carry out at least 1 right turn and 1 left turn. CARRY OUT the SASM self-test. If the DTC does not return, the repair is complete. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article

This DTC sets if the information received from the SASM does not agree with other inputs. CARRY OUT the Adaptive Steering Wheel Angle Sensor Trim function. CYCLE the ignition from ON to OFF and back to ON. DRIVE the vehicle and CARRY OUT at least 1 right turn and 1 left turn. CARRY OUT the SCCM self-test. If the DTC does not return, the repair is complete. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the appropriate Removal and Installation procedure in Supplemental Restraint System article