Tire Pressure Monitoring System DTCS: BCM
| DTC | Description | Action |
|---|---|---|
| B1182:00 | Tire Pressure Monitoring System: No Sub Type Information | GO to Pinpoint Test A |
| B1182:55 | Tire Pressure Monitoring System: Not Configured | This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC clears when the BCM is correctly configured, all 4 TPMS sensors are trained to the BCM and the BCM self-test completes successfully. Using a diagnostic scan tool, CONFIGURE the BCM. FOLLOW all diagnostic scan tool instructions. TRAIN the TPMS sensors, Refer to Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . CARRY OUT a BCM self-test to clear the DTC. |
| B124D:02 | Tire Pressure Sensor: General Signal Failure | GO to Pinpoint Test C |
| B1254:51 | Right Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. TRAIN the TPMS sensors, Refer to Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . |
| B1255:51 | Left Rear (Outside On Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. TRAIN the TPMS sensors, Refer to Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . |
| C1A56:51 | Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. TRAIN the TPMS sensors, Refer to Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . |
| C1A58:51 | Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed | This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS sensors locations are trained to the BCM. TRAIN the TPMS sensors, Refer to Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . |
| U0559:56 | Invalid Data Received from Radio Transceiver: Invalid / Incomplete Configuration | CHECK the service history for recent service actions related to the RTM. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with the RTM, REPEAT the PMI procedure as directed by the diagnostic scan tool. If there have been no recent service actions with the RTM, INSTALL a new RTM to correct the failure to retain the configuration data. Refer to Radio Transceiver Module (RTM) . |
| -- | All Other BCM Diagnostic Trouble Codes (DTCs) | REFER to Body Control Module (BCM) . |