Information and Entertainment System Vehicles With: AM/FM/CD/SYNC/Touchscreen Display DTCS: ACM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1A01:01 | Speaker #1: General Electrical Failure | For a LHF door speaker concern, GO to Pinpoint Test H For a LH instrument panel tweeter speaker concern, GO to Pinpoint Test I |
| B1A01:11 | Speaker #1: Circuit Short To Ground | For a LHF door speaker concern, GO to Pinpoint Test H For a LH instrument panel tweeter speaker concern, GO to Pinpoint Test I |
| B1A01:12 | Speaker #1: Circuit Short To Battery | For a LHF door speaker concern, GO to Pinpoint Test H For a LH instrument panel tweeter speaker concern, GO to Pinpoint Test I |
| B1A01:13 | Speaker #1: Circuit Open | For a LHF door speaker concern, GO to Pinpoint Test H For a LH instrument panel tweeter speaker concern, GO to Pinpoint Test I |
| B1A02:01 | Speaker #2: General Electrical Failure | For a RHF door speaker concern, GO to Pinpoint Test J For a RH instrument panel tweeter speaker concern, GO to Pinpoint Test K |
| B1A02:11 | Speaker #2: Circuit Short To Ground | For a RHF door speaker concern, GO to Pinpoint Test J For a RH instrument panel tweeter speaker concern, GO to Pinpoint Test K |
| B1A02:12 | Speaker #2: Circuit Short To Battery | For a RHF door speaker concern, GO to Pinpoint Test J For a RH instrument panel tweeter speaker concern, GO to Pinpoint Test K |
| B1A02:13 | Speaker #2: Circuit Open | For a RHF door speaker concern, GO to Pinpoint Test J For a RH instrument panel tweeter speaker concern, GO to Pinpoint Test K |
| B1A03:01 | Speaker #3: General Electrical Failure | GO to Pinpoint Test L |
| B1A03:11 | Speaker #3: Circuit Short To Ground | GO to Pinpoint Test L |
| B1A03:12 | Speaker #3: Circuit Short To Battery | GO to Pinpoint Test L |
| B1A03:13 | Speaker #3: Circuit Open | GO to Pinpoint Test L |
| B1A04:01 | Speaker #4: General Electrical Failure | GO to Pinpoint Test M |
| B1A04:11 | Speaker #4: Circuit Short To Ground | GO to Pinpoint Test M |
| B1A04:12 | Speaker #4: Circuit Short To Battery | GO to Pinpoint Test M |
| B1A04:13 | Speaker #4: Circuit Open | GO to Pinpoint Test M |
| B1A56:21 | Antenna: Signal Amplitude < Minimum | If DTC B1A56:21 sets after running the bezel diagnostic tests, DISREGARD this DTC. This test is used for end of line or repair bay testing at the Ford plant. Each plant has its own assigned frequency and signal strength requirements. The running and passing of this test depends on local radio stations. If no local station is broadcasting on the required frequency, the test will fail. |
| B1A89:11 | Satellite Antenna: Circuit Short To Ground | For a satellite radio concern, GO to Pinpoint Test B For a SIRIUS Travel Link concern, GO to Pinpoint Test C For a navigation concern (if equipped), GO to Pinpoint Test Y For a compass concern, GO to Pinpoint Test Z |
| B1A89:13 | Satellite Antenna: Circuit Open | For a satellite radio concern, GO to Pinpoint Test B For a SIRIUS Travel Link concern, GO to Pinpoint Test C For a navigation concern (if equipped), GO to Pinpoint Test Y For a compass concern, GO to Pinpoint Test Z |
| B1D19:49 | Compact Disc Unit: Internal Electronic Failure | GO to Pinpoint Test X |
| B1D19:4B | Compact Disc Unit: Over Temperature | GO to Pinpoint Test X |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test AE |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AH |
| U0256:00 | Lost Communication With Front Controls Interface Module "A": No Sub Type Information | GO to Pinpoint Test AI |
| U0257:00 | Lost Communication With Front Control/Display Interface Module: No Sub Type Information | GO to Pinpoint Test AJ |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incomplete or incorrect ACM PMI. CHECK the vehicle service history for recent service actions related to the ACM. If there have been recent service actions with the ACM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. If there have been no recent service actions, the ACM has failed to retain configuration data. INSTALL a new ACM. Refer to: Audio Unit Antenna . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incomplete or incorrect ACM PMI. CHECK the vehicle service history for recent service actions related to the ACM. If there have been recent service actions with the ACM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. If there have been no recent service actions, the ACM has failed to retain configuration data. INSTALL a new ACM. Refer to: Audio Unit Antenna . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incomplete or incorrect ACM PMI. CHECK the vehicle service history for recent service actions related to the ACM. If there have been recent service actions with the ACM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. If there have been no recent service actions, the ACM has failed to retain configuration data. INSTALL a new ACM. Refer to: Audio Unit Antenna . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new ACM. Refer to: Audio Unit Antenna . |
| U3000:42 | Control Module: General Memory Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new ACM. Refer to: Audio Unit Antenna . |
| U3000:96 | Control Module: Component Internal Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:96 is retrieved again, INSTALL a new ACM. Refer to: Audio Unit Antenna . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AK |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AL |