Instrumentation, Message Center, And Warning Chimes DTCS: IPC
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1A14:11 | RCM Warning Lamp: Circuit Short To Ground | Refer to IPC Hardware Testing . DIAGNOSE all RCM Diagnostic Trouble Codes (DTCs). Refer to: Airbag Supplemental Restraint System (SRS) . |
| B1A14:13 | RCM Warning Lamp: Circuit Open | Refer to IPC Hardware Testing . DIAGNOSE all RCM Diagnostic Trouble Codes (DTCs). Refer to: Airbag Supplemental Restraint System (SRS) . |
| B1A84:41 | Car Configuration Data: General Checksum Failure | This DTC may set after replacement of the IPC. To CLEAR this DTC CARRY OUT the car configuration procedure listed for BCM replacement. Refer to: Body Control Module (BCM) . |
| B1A84:51 | Car Configuration Data: Not Programmed | This DTC may set after replacement of the IPC. To CLEAR this DTC CARRY OUT the car configuration procedure listed for BCM replacement. Refer to: Body Control Module (BCM) . |
| C1D00:00 | Park Brake Apply Switch: No Sub Type Information | GO to Pinpoint Test N |
| C2003:11 | Steering Wheel Switch Left Module: Circuit Short To Ground | GO to Pinpoint Test AB |
| C2003:23 | Steering Wheel Switch Left Module: Signal Stuck Low | GO to Pinpoint Test AB |
| P1607:81 | MIL Output Circuit: Invalid Serial Data Received | This DTC sets when the IPC receives an invalid MIL request message for more than 5 seconds. CLEAR the DTC. REPEAT the self-test. If DTC P1607:81 returns, INSTALL a new PCM. REFER to: Powertrain Control Module (PCM) . |
| P1607:82 | MIL Output Circuit: Alive/Sequence Counter Incorrect/Not Updated | This DTC sets when the IPC does not receive an updated MIL request message for more than 5 seconds. CLEAR the DTC. REPEAT the self-test. If DTC U0100:00 is also present, GO to Pinpoint Test AT If DTC P1607:82 returns without DTC U0100:00, INSTALL a new PCM. REFER to: Powertrain Control Module (PCM) . |
| P1607:87 | MIL Output Circuit: Missing Message | This DTC sets when the IPC does not receive updated MIL request message for more than 5 seconds. CLEAR the DTC. REPEAT the self-test. If DTC U0100:00 is also present, GO to Pinpoint Test AT If DTC P1607:87 returns without DTC U0100:00, INSTALL a new PCM. REFER to: Powertrain Control Module (PCM) . |
| P1706:00 | High Vehicle Speed Observed in Park: No Sub Type Information | GO to Pinpoint Test W |
| P1933:68 | Fuel Level Signal: Event Information | GO to Pinpoint Test B |
| U0073:00 | Control Module Communication Bus "A" Off: No Sub Type Information | REFER to: Communications Network . |
| U0074:00 | Control Module Communication Bus "B" Off: No Sub Type Information | REFER to: Communications Network . |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test AT |
| U0101:00 | Lost Communication With TCM: No Sub Type Information | GO to Pinpoint Test AU |
| U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module: No Sub Type Information | GO to Pinpoint Test AV |
| U0131:00 | Lost Communication With Power Steering Control Module: No Sub Type Information | GO to Pinpoint Test AW |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AX |
| U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | GO to Pinpoint Test AY |
| U0159:00 | Lost Communication With Parking Assist Control Module "A": No Sub Type Information | GO to Pinpoint Test AZ |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test BA |
| U0232:00 | Lost Communication With Side Obstacle Detection Control Module-Left: No Sub Type Information | GO to Pinpoint Test BB |
| U0233:00 | Lost Communication With Side Obstacle Detection Control Module-Right: No Sub Type Information | GO to Pinpoint Test BB |
| U0401:64 | Invalid Data Received From ECM/PCM A: Signal Plausibility Failure | This DTC sets when a message is temporarily undefined for more than 2 seconds from the PCM for the ambient temperature, fuel economy, engine coolant temperature or engine rpm data. CLEAR the DTC. REPEAT the self-test. If DTC U0401:64 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the PCM. Refer to Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid) . |
| U0415:64 | Invalid Data Received From Anti-Lock Brake System (ABS) Control Module: Signal Plausibility Failure | This DTC sets when the wheel rotation count message is temporarily undefined for more than 2 seconds from the ABS module for the odometer. CLEAR the DTC. REPEAT the self-test. If DTC U0415:64 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the ABS module. Refer to: Anti-Lock Brake System (ABS) and Stability Control . |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | This DTC sets when the power mode or vehicle speed message is invalid for more than 2 seconds or if the TPMS status message is missing for more than 1, 250 milliseconds from the BCM. CLEAR the DTC. REPEAT the self-test. If DTC U0422:00 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the BCM. Refer to: Body Control Module (BCM) . |
| U0422:68 | Invalid Data Received From Body Control Module: Event Information | This DTC sets when the ambient air temperature message is missing for more than 2 seconds from the BCM. CLEAR the DTC. REPEAT the self-test. If DTC U0422:68 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the BCM. Refer to: Body Control Module (BCM) . |
| U0424:00 | Invalid Data Received From HVAC Control Module: No Sub Type Information | This DTC sets when the temperature range data is invalid for more than 2 seconds from the HVAC module through the BCM. CLEAR the DTC. REPEAT the self-test. If DTC U0424:00 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the HVAC module. Refer to: Climate Control System - Vehicles With: Electronic Manual Temperature Control (EMTC) . Refer to: Climate Control System - Vehicles With: Dual Automatic Temperature Control (DATC) . |
| U0452:00 | Invalid Data Received From Restraints Control Module: No Sub Type Information | This DTC sets when data sent from the RCM is invalid for 2 seconds or longer. CLEAR the DTC. REPEAT the self-test. If DTC U0452:00 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the RCM. Refer to: Airbag Supplemental Restraint System (SRS) . |
| U0558:00 | Invalid Data Received From Front Controls/Display Interface Module: No Sub Type Information | This DTC sets when data sent from the FCDIM is invalid for 10 seconds or longer. CLEAR the DTC. REPEAT the self-test. If DTC U0558:00 returns, RETRIEVE and REPAIR all Diagnostic Trouble Codes (DTCs) set in the RCM. Refer to: Airbag Supplemental Restraint System (SRS) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. Install As-Built data from Professional Technician Society (PTS) following scan tool instructions under Module Programming>As-Built. |
| U2101:01 | Control Module Configuration Incompatible: General Electrical Failure | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. Install As-Built data from Professional Technician Society (PTS) following scan tool instructions under Module Programming>As-Built. |
| U3000:41 | Control Module: General Checksum Failure | This DTC sets due to an internal configuration failure in the ROM, NVM, or odometer EEPROM. Install As-Built data from Professional Technician Society (PTS) following scan tool instructions under Module Programming>As-Built. CLEAR the DTC. REPEAT the self-test. If DTC U3000:41 returns, Refer to IPC Hardware Testing . |
| U3006:16 | Control Module Input Power "A": Circuit Voltage Below Threshold | GO to Pinpoint Test BC |
| U3006:17 | Control Module Input Power "A": Circuit Voltage Above Threshold | GO to Pinpoint Test BD |