Module configuration and parameter chart

The charts describe specific module configuration information:

Module name	Module address	Programmable module installation (pmi) available	Reprogram/flash capable	Requires adaptive learning or calibration	Available progammable parameters
Accm	7c7	No	No	No	None
Apim	7d8	Yes	Yes	No	None
Abs module	760	Yes	Yes	Abs bleed Multi-calibration routine Inlet valve calibration Master cylinder isolation calibration Ivd initialization	None
Acm	727	Yes	Yes	No	None
Becm - phev	7e4	Yes	Yes	No	None
Becm - non plug-in hev	7e4	Yes	Yes	No	None
Bcm	726	Yes	Yes	No	Approach light disable Battery charge curve Battery cap Drip wipe pause time Fuel supply Rain sensor car code Trunk illumination Wash activation in acc
Dacmc	7dd	Yes	Yes	No	None
Dc to dc converter control module (dc/dc)	746	No	Yes	No	None
Ddm	740	Yes	Yes	No	None
Fcim	7a7	No	No	No	None
Fcdim	7a5	Yes	Yes	No	None
Gwm	716	Yes	Yes	No	None
Gfm (charge port light ring)	7a3	No	No	No	None
Gpsm (without touchscreen)	701	Yes	Yes	No	None
Hvac module	733	Yes	Yes	No	None
Ipc	720	Yes	Yes	No	Front fog lamps Mykey volume Remote start Climate control Driver seat Passenger seat Rear defrost Blis enable/disable Cta enable/disable
Rgtm	775	No	Yes	No	None
Ocsm	765	No	No	Ocsm re-zero	None
Pam	736	No	Yes	No	None
Pscm	730	No	No	No	None
Pcm	7e0	Yes	Yes	No	None
Pdm	741	Yes	Yes	No	None
Rfa module	731	No	No	No	Passive entry/passive start (peps)
Rcm	737	Yes	Yes	No	None
Sobdm	7e2	No	Yes	No	None
Sasm	79f	No	No	No	None
Sobdmc (tcm)	7e6	Yes	Yes	No	None
Sodl	7c4	Yes	Yes	No	None
Sodr	7c6	Yes	Yes	No	None
Tcu	75c	Yes	Yes	No	None

Body control module (BCM) and instrument panel cluster (IPC)

NOTE: The body control module (bcm) and IPC have a unique procedure to set car configuration parameters. Configuration changes made affect both modules. On the scan tool, first select module programming > programmable parameters > car configuration parameter(s) > vehicle configuration > retrieve the vehicle configuration data. Next select module programming > programmable parameters > car configuration parameter(s) > vehicle configuration > modify and reinstate vehicle configuration data. Change parameters as needed.

Module name	Module address	Programmable module installation (pmi) available	Reprogram/flash capable	Requires adaptive learning or calibration	Available car configuration parameters
Bcm	726	Yes (through car configuration parameters. Refer to: Body control module (bcm)	Yes	No	NOTE: Do not change car configuration parameters except those listed below. Seat belt warning (belt-minder®)Front passenger seat belt warning (belt-minder®)English/metricLanguageMykey®Two-stage unlock (with slam lock)Autolock/unlockPerimeter alarmService intervalTire sizeBattery amperageCourtesy wipe disableGlobal open/close disableRemote start
Ipc	720	Yes	Yes	No