April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test AF: ABS Module VIN Mismatch

AF1: VERIFY THE ABS MODULE DTC

Ignition ON, engine OFF.
Clear the ABS DTCs.
Carry out the ABS self-test.
Is DTC U3002 still present in the ABS module?

Yes	No
Go to AF2.	The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

AF2: VERIFY THE NETWORK COMMUNICATION

Ignition ON, engine OFF.
Using a diagnostic scan tool, carry out the Network Test.
Record all No Communication and Invalid Data DTCs.
Do all equipped modules communicate with the diagnostic scan tool?

Yes	No
Go to AF3.	DIAGNOSE the module does not respond to the diagnostic scan tool. REFER to COMMUNICATIONS NETWORK

AF3: CHECK FOR COMMUNICATION DTCS

Are there any No Communication or any Invalid Data DTCs present in the ABS module?

Yes	No
REFER to the ABS - ANTILOCK BRAKING SYSTEM DTC INDEX . DIAGNOSE all No Communication and Invalid Data DTCs in the ABS module before diagnosing this DTC.	Go to AF4.

AF4: CONFIGURE THE ABS MODULE USING PMI

Ignition ON, engine OFF.
Using a diagnostic scan tool, configure the ABS module using PMI. Follow all scan tool directions.
Ignition OFF.
Ignition ON, engine OFF.
Clear the ABS DTCs.
Carry out the ABS self-test.
Is DTC U3002 still present in the ABS module?

Yes	No
	The system is operating correctly. The concern was caused by an incomplete or improper programming session.

AF5: CONFIGURE THE ABS MODULE USING AS-BUILT DATA

Ignition ON, engine OFF.
Using a diagnostic scan tool, configure the ABS module using As-Built Data. Follow all scan tool directions.
Ignition OFF.
Ignition ON, engine OFF.
Clear the ABS DTCs.
NOTE: To access the ABS ECU Reset routine when using Ford IDS, go to Chassis, then Braking and click ABS ECU Reset.
Using a diagnostic scan tool, carry out the ABS ECU Reset routine.
Carry out the ABS self-test.
Is DTC U3002 still present in the ABS module?

Yes	No
Using a diagnostic scan tool, PROGRAM the PCM using PMI. FOLLOW all scan tool directions. REFER to MODULE CONFIGURATION (EXCEPT ELECTRIC) .	The system is operating correctly. The concern was caused by an incomplete or improper programming session.