Powertrain Control Module (PCM): Installation

To install, reverse the removal procedure.
NOTE: This step is only necessary when installing a new component.

Upload the module information from the diagnostic tool using the Programmable Modules Installation routine.

Use the General Equipment: Ford Diagnostic Equipment
NOTE: The step is only necessary when installing a new component.
- Carry out the Parameter Reset procedure.
- Vehicles without keyless entry and push button start. Refer to: Anti-Theft Key Programming - Scan Tool .
- Vehicles with keyless entry and push button start. Refer to: Anti-Theft Key Programming - Scan Tool .
Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.