Supplemental Restraint System DTCS: BECMB
NOTE:
Always make sure the correct SRS component is being installed. Parts released for other vehicles may not be compatible even if they appear physically similar. Check the part number listed in the parts catalog to make sure the correct component is being installed. If an incorrect SRS component is installed, DTCs may set.
NOTE:
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to Diagnostic Methods in Service Information
for information about these practices.
DTC INDEX
| DTC | Description | Action To Take |
|---|---|---|
| B00A0:11 | Occupant Classification System: Circuit Short To Ground | GO to Pinpoint Test AV . |
| B00A0:12 | Occupant Classification System: Circuit Short To Battery | GO to Pinpoint Test AV . |
| B1123:11 | Restraints Ignition Relay: Circuit Short To Ground | GO to Pinpoint Test AV . |
| B1123:12 | Restraints Ignition Relay: Circuit Short To Battery | GO to Pinpoint Test AV . |
| B1142:62 | Ignition Status 1: Signal Compare Failure | GO to Pinpoint Test AW . |
| B13BF:12 | Run/Start Input: Circuit Short to Battery | GO to Pinpoint Test AW . |
| U0100:87 | Lost Communication with ECM/PCM A: Missing Message | GO to Pinpoint Test AX . |
| U0140:87 | Lost Communication with Body Control Module: Missing Message | GO to Pinpoint Test AY . |
| U1000:00 | Solid State Driver Protection Active -Driver Disabled: No Sub Type Information | DIAGNOSE any other Extended Power Module (BECMB) DTCs first. CLEAR the DTCs. REPEAT the self-test. If DTC U1000:00 returns, INSTALL a new Extended Power Module (BECMB). REFER to Battery Energy Control Module B (BECMB) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK vehicle history for recent service actions related to this module. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the diagnostic scan tool using As-Built data. |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new Extended Power Module (BECMB). REFER to Battery Energy Control Module B (BECMB) . |