Side & Rear Vision DTCS
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in GENERAL INFORMATION for information about these practices.
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to Pinpoint Test D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | If the LED is not illuminated, GO to Pinpoint Test D . If the LED is always on, GO to Pinpoint Test I . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test J . |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | DTC U0423:00 is set when the SOD-L or SOD-R receives invalid network data from the IPC. RETRIEVE and REPAIR all non-network DTCs in the IPC. REFER to INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | The Side Obstacle Detection Control Module - Left(SOD-L) or Side Obstacle Detection Control Module - Right(SOD-R) is not configured. REFER to MODULE CONFIGURATION for Programmable Module Installation(PMI) to configure the SOD-L or SOD-R. |
| U3000:44 | Control Module: Data Memory Failure | GO to Pinpoint Test H . |
| U3000:45 | Control Module: Program Memory Failure | GO to Pinpoint Test H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to Pinpoint Test H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to Pinpoint Test H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to Pinpoint Test H . |