Steering Column Switches DTCS: BCM
NOTE:
Any push-button start system fault results in DTCs being stored in the Remote Function Actuator(RFA) module and BCM. Correct all RFA module DTCs prior to diagnosing the BCM DTCs listed below.
| DTC | Description | Action |
|---|---|---|
| B108A:01 | Start Button: General Electrical Failure | GO to Pinpoint Test J . |
| B1142:29 | Ignition Status 1: Signal Invalid | GO to Pinpoint Test J . |
| B1240:11 | Start Button Mode Indicator: Circuit Short to Ground | GO to Pinpoint Test I . |
| B1240:15 | Start Button Mode Indicator: Circuit Short to Battery or Open | GO to Pinpoint Test I . |
| B1310:12 | Run/Start Control: Circuit Short to Battery | GO to Pinpoint Test O . |
| B1310:14 | Run/Start Control: Circuit Short to Ground or Open | For vehicles equipped with an ignition switch, GO to Pinpoint Test C . For vehicles equipped with a start/stop switch, GO to Pinpoint Test E . |
| U300A:01 | Ignition Switch: General Electric Failure | GO to Pinpoint Test A . |
| All other BCM DTCs | -- | REFER to DIAGNOSIS AND TESTING . |