| B00A0:11 |
Occupant Classification System: Circuit Short To Ground |
GO to Pinpoint Test AP
. |
| B00A0:12 |
Occupant Classification System: Circuit Short To Battery |
GO to Pinpoint Test AP
. |
| B1123:11 |
Restraints Ignition Relay: Circuit Short To Ground |
GO to Pinpoint Test AP
. |
| B1123:12 |
Restraints Ignition Relay: Circuit Short To Battery |
GO to Pinpoint Test AP
. |
| B1142:62 |
Ignition Status 1: Signal Compare Failure |
GO to Pinpoint Test AQ
. |
| B13BF:12 |
Run/Start Input: Circuit Short to Battery |
GO to Pinpoint Test AQ
. |
| U0100:87 |
Lost Communication with ECM/PCM A: Missing Message |
GO to Pinpoint Test AR
. |
| U0140:87 |
Lost Communication with Body Control Module: Missing Message |
GO to Pinpoint Test AS
. |
| U1000:00 |
Solid State Driver Protection Active -Driver Disabled: No Sub Type Information |
DIAGNOSE any other Extended Power Module (BECMB) DTCs first. CLEAR the DTCs. REPEAT the self-test. If DTC U1000:00 returns, INSTALL a new Extended Power Module (BECMB). REFER to Battery Energy Control Module B (BECMB)
. |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
CHECK vehicle history for recent service actions related to this module. This DTC sets due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the diagnostic scan tool using As-Built data. |
| U3000:49 |
Control Module: Internal Electronic Failure |
INSTALL a new Extended Power Module (BECMB). REFER to Battery Energy Control Module B (BECMB)
. |