Common Specifications & Procedures
GT COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | Specifications | |||
| Torque | Refer to the specific component in Removal And Installation | |||
| Axle Nut/Hub Nut | ||||
| Torque | Stage 1: 98 lb.ft (133 Nm) Stage 2: 45° |
|||
| Battery | ||||
| Specifications | ||||
| Brakes | ||||
| Bleeding Sequence | RR, LR, RF, LF Brake System Pressure Bleeding . |
|||
| Disc Brakes | ||||
| Front w/Torque | Refer to the specific component in Removal And Installation | |||
| Rear w/Torque | Refer to the specific component in Removal And Installation . | |||
| Charging | ||||
| Generator w/Torque | ||||
| Generator Bolt | 18 lb.ft (25 Nm) | |||
| Drive Belts | ||||
| Adjustment | Accessory Drive Belt | |||
| Belt Routing | Accessory Drive - Component Location | |||
| Engine Cooling | ||||
| General Service Specifications | Specifications | |||
| Radiator Cap Pressure | 145 kPa (21 psi) | |||
| Thermostat R & I | Thermostat | |||
| Water Pump R & I | Coolant Pump . | |||
| Engine Mechanical | ||||
| Compression | Specifications | |||
| Oil pressure @ 1, 500 rpm with engine at normal operating temperature | 39.9 psi (275 kPa) | |||
| Overhaul | Specifications | |||
| Torque | Refer to the specific component in Removal And Installation | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |||
| Starter Ring Gear Torque | ||||
| For tightening sequence refer to Starter Ring Gear 74 lb.ft (100 Nm) |
||||
| Fuel System | ||||
| Fuel Filter R & I | Fuel Filter | |||
| Pressure Release Procedure | Fuel System Pressure Release | |||
| Pressure Specification | Specifications | |||
| Fuel Pressure Test Procedure | Fuel System Pressure Check . | |||
| Ignition | ||||
| Ignition Wires | Engine has coil-on-plug ignition. | |||
| Firing Order & Cylinder Identification | Firing Order & Cylinder Identification | |||
| Spark Plugs | ||||
| Type | N/A | |||
| Gap | 0.030 in (.75 mm) | |||
| Torque | 133 lb.in (15 Nm) | |||
| Starting | ||||
| Starter w/Torque | 35 lb.ft (48 Nm) | |||
| Wheel Alignment | ||||
| Adjustment Specifications | Specifications | |||
| Torque | Refer to the appropriate Procedure in General Procedures | |||
| Wheel & Tire | ||||
| Tightening Sequence | For the tightening sequence, Refer to Wheel And Tire . | |||
| Wheel Lug Nut Torque | 150 Ft. Lbs. (204 N.m) | |||