| B10C7:01 |
Interior Trunk Antenna: General Electrical Failure |
GO to Pinpoint Test A
. |
| B10C8:01 |
Interior Centre Antenna: General Electrical Failure |
GO to Pinpoint Test A
. |
| B10C9:01 |
Interior Front Antenna: General Electrical Failure |
GO to Pinpoint Test A
. |
| B10D7:05 |
PATS Key: System Programming Failure |
GO to Pinpoint Test D
. |
| B10D8:51 |
PATS Key Less Than Minimum Programmed: Not Programmed |
If other PATS DTCs are present, address them first. If DTC B10D8:51 is the only DTC present, PROGRAM additional keys (minimum of 2 keys must be programmed). REFER to Key Programming Using Diagnostic Equipment
. |
| B10D9:11 |
PATS Transponder: Circuit Short to Ground |
GO to Pinpoint Test E
. |
| B10D9:12 |
PATS Transponder: Circuit Short to Battery |
GO to Pinpoint Test E
. |
| B10D9:31 |
PATS Transponder: No Signal |
GO to Pinpoint Test E
. |
| B10D9:87 |
PATS Transponder: Missing Message |
GO to Pinpoint Test E
. |
| B10DA:51 |
PATS Target Identifier: Not Programmed |
There is no PCM identification stored in the RFA module. CARRY OUT a parameter reset, then CYCLE the ignition and make an attempt to start the vehicle. REFER to Passive Anti-Theft System (PATS) Parameter Reset
. |
| B10DA:61 |
PATS Target Identifier: Signal Calculation Failure |
There is an incorrect PCM ID stored in the RFA module. CARRY OUT a parameter reset, then CYCLE the ignition and make an attempt to start the vehicle. REFER to Passive Anti-Theft System (PATS) Parameter Reset
. |
| U201F:31 |
External Receiver: No Signal |
REFER to Handles, Locks, Latches and Entry Systems - With Intelligent Access (IA)
. |
| All other DTCs |
-- |
REFER to the RFA module DTC Chart in Multifunction Electronic Modules
. |