| B10D5:13 |
PATS Antenna: Circuit Open |
The BCM received an incomplete or corrupt response from the PATS transceiver. INSTALL a new PATS transceiver. REFER to Passive Anti-Theft System (PATS) Transceiver
. |
| B10D7:05 |
PATS Key: System Programming Failure |
GO to Pinpoint Test B
. |
| B10D7:87 |
PATS Key: Missing Message |
GO to Pinpoint Test C
. |
| B10D7:8F |
PATS Key: Erratic |
GO to Pinpoint Test C
. |
| B10D9:87 |
PATS Transponder: Missing Message |
GO to Pinpoint Test D
. |
| B10DA:51 |
PATS Target Identifier: Not Programmed |
There is no PCM ID stored in the BCM. CARRY OUT a parameter reset. REFER to Passive Anti-Theft System (PATS) Parameter Reset
. CLEAR the DTCs. REPEAT the self-test. |
| B130D:00 |
Memory Full for Integrated Key Programming: No Sub Type Information |
The maximum amount of IKTs (4) have been programmed into the BCM. OBTAIN all the customer's IKTs. ERASE all the and PROGRAM a maximum of 4. REFER to Erase All Keys and Program Two Keys
. |
| C113A:11 |
Wakeup Control: Circuit Short To Ground |
GO to Pinpoint Test E
. |
| C113A:15 |
Wakeup Control: Circuit Short To Battery or Open |
GO to Pinpoint Test E
. |
| All other DTCs |
-- |
REFER to the BCM DTC Chart in Multifunction Electronic Modules
. |