| B11D6:11 |
Driver Display Alert LED: Circuit Short To Ground |
GO to Pinpoint Test D
. |
| B11D6:15 |
Driver Display Alert LED: Circuit Short To Battery Or Open |
If the LED is not illuminated GO to Pinpoint Test D
. If the LED is always on GO to Pinpoint Test I
. |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
The Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is not configured. REFER to Module Configuration
for Programmable Module Installation(PMI) to configure the SOD-L or SOD-R. |
| U0140:00 |
Lost Communication With Body Control Module: No Sub Type Information |
GO to Pinpoint Test J
. |
| U0423:00 |
Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information |
DTC U0423:00 is set when the SOD-L or SOD-R receives invalid network data from the IPC. RETRIEVE and REPAIR all non-network DTCs in the IPC. REFER to INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES
. |
| U3000:44 |
Control Module: Data Failure |
GO to Pinpoint Test H
. |
| U3000:45 |
Control Module: Program Memory Failure |
GO to Pinpoint Test H
. |
| U3000:46 |
Control Module: Calibration/Parameter Memory Failure |
GO to Pinpoint Test H
. |
| U3000:48 |
Control Module: Supervision Software Failure |
GO to Pinpoint Test H
. |
| U3000:49 |
Control Module: Internal Electronic Failure |
GO to Pinpoint Test H
. |
| U3000:4A |
Control Module: Incorrect Component Installed |
GO to Pinpoint Test H
. |