General Information
- Description And Operation
- About This Service Information
- Introduction
- Warnings, Notices and Notes
- Safety Relevant Systems
- Specified Chemicals or Materials
- LH and RH Designations
- Standard Practices
- Mechanical Procedures
- Notes
- Illustration Color-coding
- Illustration Task Sequence
- Simple procedure example showing color-coding and task sequence.
- Examples of fastener removal sequence and an identical service action for 12 fasteners. Other possible symbols are shown on the right.
- Example of fastener sequence information with two persons required for the service action
- Hidden Details
- Example of hidden fastener information
- Service Action Icons
- Location symbols show the location of a component or system on the vehicle.
- Example of service action icons pointing to highlighted components.
- Movement arrows and service action icons show three dimensional or rotational movements.
- Instruction symbols are used to apply sealer, lubricant, weight, tape or cleaning detergent to a component.
- Measurement symbols provide the information required to perform a specific measurement. These symbols may include specific values.
- Special Tools, Equipment, Materials And Torque Values
- Example of special service tool and symbol used to hold the gear shift in the required gear position. Other possible symbols are shown on the right.
- Example of two illustrations used together with sequence steps, service action icons and special service tools
- Tool symbols direct the use of standard tools. The tool size or dimension may be specified.
- Health And Safety Symbols
- ISO warning symbols may be used to indicate potential hazards.
- These symbols prohibit various hazardous actions
- These symbols direct the use of personal protection equipment
- Diagnosis and Testing Information
- Symbols Glossary
- Notes
- Movement Symbols
- Turn Symbols
- Steering Wheel Symbols
- Body Types
- Gearshift lever and selector lever position symbols
- Screwdriver symbols
- Pliers symbols
- Drill symbols
- Cutting tool symbols
- Apply Chemical or load symbols
- Measurement symbols
- General equipment symbols
- Welding symbols
- Drilling and grinding symbols
- Material symbols
- Miscellaneous symbols
- Mandatory Protective equipment - Health and safety symbols
- Prohibition - Health and safety symbols and component damage
- Warning symbols - Health and safety and component damage
- Control Diagram symbols - Description and Operation procedures
- Health and Safety Precautions
- Battery and Battery Charging Health and Safety Precautions
- Body Repair Health and Safety and General Precautions
- Brake and Clutch Systems Health and Safety Precautions
- Climate Control System Health and Safety Precautions
- Diagnostic Methods
- Effective Diagnostic Techniques
- Diagnostic Scan Tool Testing
- Integrated Diagnostic System Scan Tool Usage
- Measuring Automotive Circuits
- Wiring Pin (Terminal) Fit And The Use Of Rotunda Flex Probes
- Checking Power-Providing Circuits
- Checking Ground-Providing Circuits
- Checking Circuit Continuity
- Checking For Unintended Continuity (Shorts) To Other Circuits
- Checking Circuits By Back-Probing A Connector
- Circuit Analysis Using Jumper Wires (Creating Substitute Circuits)
- Checking Modules
- Diesel Fuel System Health and Safety Precautions
- Engine Cooling System Health and Safety Precautions
- Gasoline and Gasoline-Ethanol Fuel Systems Health and Safety Precautions
- Liquefied Petroleum Gas (LPG) and Compressed Natural Gas (CNG) Fuel Systems Health and Safety Precautions
- Pyrotechnic Device Health and Safety Precautions
- Wheel and Tire Health and Safety Precautions
- About This Service Information
- Diagnosis And Testing
- General Procedures