| B10D5:94 |
PATS Antenna: Unexpected Operation |
The BCM received an incomplete or corrupt response from the PATS transceiver. INSTALL a new PATS transceiver. |
| B10D7:05 |
PATS Key: System Programming Failure |
GO to Pinpoint Test B |
| B10D7:51 |
PATS Key: Not Programmed |
There is an unprogrammed PATS key. PROGRAM the PATS key. |
| B10D7:55 |
PATS Key: Not Configured |
The BCM Configurable Engine Immobilizer (CEI) was not configured after PMI. FOLLOW the diagnostic scan tool on-screen instructions after the PMI process to perform the Configurable Engine Immobilizer (CEI) Lock Configuration. |
| B10D7:81 |
PATS Key: Invalid Serial Data Received |
GO to Pinpoint Test C |
| B10D7:87 |
PATS Key: Missing Message |
GO to Pinpoint Test D |
| B10D7:94 |
PATS Key: Unexpected Operation |
GO to Pinpoint Test C |
| B10D8:00 |
PATS Key Less Than Minimum Programmed: No Sub Type Information |
Less than the minimum required keys are programmed. Use a diagnostic scan tool and VIEW the BCM Minimum number of keys required (MIN_KEYS_RQD) PID. CYCLE the customer's additional key(s) in the ignition to complete the key programming procedure. When less than the minimum keys are programmed, the BCM automatically programs the first 2 keys (or 4 keys dependent on vehicle build) that are cycled in the ignition lock cylinder. |
| B10DA:51 |
PATS Target Identifier: Not Programmed |
There is no BCM ID stored in the BCM memory. CARRY OUT a parameter reset. |
| All other Diagnostic Trouble Codes (DTCs) |
- |
REFER to: Body Control Module (BCM)
. |