Normal Operation and Fault Conditions
With the ignition ON, the APIM sends messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within the allotted time frame, the module sets a DTC. This can be due to an APIM failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the air suspension control module, refer to the Network Message Chart in Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article.
PPT CL ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | This DTC sets in the ABS module when the auto hold switch status message from the APIM is not received in the allotted time. |
| U0554:86 | Invalid Data Received From Accessory Protocol Interface Module: Signal Invalid | This DTC sets in the ABS module when the auto hold switch status message from the APIM is received with an invalid value. |