LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2020 >> Edge ST-Line, 4WD >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Abs Guided Routine >> Pinpoint Tests >> Pinpoint Tests Z: Module Configuration Concern >> Normal Operation and Fault Conditions
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Normal Operation and Fault Conditions

During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets. 

PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0300:51 Internal Control Module Software Invompatibility: Not Programmed Sets due to incomplete or improper module programming procedures.
U2017:57 Control Module Software #2: Invalid/Incompatible Software Component Sets due to incomplete or improper module programming procedures.
U2017:93 Control Module Software #2: No Operation Sets due to incomplete or improper module programming procedures.
U2024:51 Control Module Cal-Config Data: Not Programmed This DTC is only present when a new ABS module is installed, the ABS module is flashed or the ABS module is reconfigured.
U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information Sets due to incomplete or improper module programming procedures.
scientia non olet · About LEMON Manuals