DTC P062F - Internal Control Module EEPROM Error

DTC DESCRIPTION P062F - INTERNAL CONTROL MODULE EEPROM ERROR

Description:	The PCM read only memory (ROM) has been corrupted.
Possible Causes:	Aftermarket performance products An attempt was made to change the calibration PCM programming error PCM internal software error Damaged PCM
Diagnostic Aids:	Check for other DTCs and diagnose those first. Check for aftermarket performance products. Reprogram or update the calibration. Clear the DTCs and repeat the self-test. If the DTC is retrieved again, carry out the passive anti-theft system (PATS) parameter reset. Clear the DTCs and repeat the self-test. If the DTC is retrieved again, install a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the VID Block for a Replacement PCM.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	Refer to the Description, Possible Causes and Diagnostic Aids for the DTC.