Pinpoint Test CX : P1A10
- NOTE: The Inverter System Controller (ISC) is referred to as the SOBDMC (Secondary On-Board Diagnostic Control Module C) in the scan tool.
Normal Operation and Fault Conditions
REFER to: Electric Powertrain Control - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition SOBDMC P1A10:00 Hybrid Powertrain Control Module - Battery Disabled: No Sub Type Information This DTC sets when a BECM concern is detected. Possible Sources
- BECM concern
- CX1 CHECK FOR BECM (BATTERY ENERGY CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, read the CMDTCs from the BECM.
Are any BECM DTCs present?
Yes DIAGNOSE the BECM DTCs. REFER to: High Voltage Battery, Mounting and Cables - Hybrid Electric Vehicle (HEV) . No The system is operating correctly at this time. The DTC may have set due to high network traffic or an intermittent fault condition. CLEAR the Inverter System Controller (ISC) DTCs and REPEAT the self-test.