DTC P060C (SOBDMC) - Internal Control Module Main Processor Performance
DTC DESCRIPTION P060C (SOBDMC) - INTERNAL CONTROL MODULE MAIN PROCESSOR PERFORMANCE
| Description: This DTC sets when the TCM detects an out of range torque command signal, a motor output shaft speed signal plausibility fault, a read only memory (ROM) checksum fault, a random access memory (RAM) fault, a controller area network (CAN) message fault, or a transmission range (TR) sensor fault. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Diagnose other DTCs first. Verify all CAN modules are at the latest calibration level. Clear the SOBDMC DTCs. Repeat the self-test. If the DTC is retrieved again, install a new TCM. Refer to the Automatic Transmission article. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the TRID Block for a Replacement TCM. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||