DTC P0A1A - Generator Control Module
DTC DESCRIPTION P0A1A - GENERATOR CONTROL MODULE
| Description: This DTC sets when the TCM detects the difference between the generator torque estimate and command has exceeded a calibrated threshold, or if the total estimated torque has exceeded a calibrated threshold in the wrong direction. | |||
Possible Causes:
|
|||
| Diagnostic Aids: Verify the SOBDMC is at the latest calibration level. Clear the SOBDMC DTCs. Repeat the self-test. If the DTC is retrieved again, install a new TCM. Refer to the Automatic Transmission article. Refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) , Programming the TRID Block for a Replacement TCM. | |||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||