Pinpoint Test Z: Module Configuration Concern
Normal Operation and Fault Conditions
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC is set.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS C052B:93 | ABS Pump Motor Control Range/Performance: No Operation | Sets due to incomplete or improper module programming procedures. |
| ABS C05CC:00 | Brake Master Cylinder Piston Position Sensor "A" Circuit Range/Performance: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS C05CF:00 | Brake Master Cylinder Piston Position Sensor "B" Circuit Range/Performance: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS C102E:48 | Stability Control System: Supervision Software Failure | Sets due to incomplete or improper module programming procedures. |
| ABS P0604:8F | Internal Control Module Random Access Memory (RAM) Error: Erratic | Sets due to incomplete or improper module programming procedures. |
| ABS U2002:47 | Switch: Watchdog/Safety μC Failure | Sets due to incomplete or improper module programming procedures. |
| ABS U2017:57 | Control Module Software #2: Invalid/Incompatible Software Component | Sets if the RSC calibration variant and the ABS module configuration do not match. |
| ABS U2017:93 | Control Module Software #2: No Operation | Sets if the RSC control logic cannot initialize after stable driving conditions are detected. This is usually due to an incomplete or improper module programming procedures. |
| ABS U2018:57 | Control Module Software #3: Invalid/Incompatible Software Component | Sets if the selectable drive mode software and the ABS module configuration do not match. |
| ABS U202B:61 | In-Use Application Signing Key: Signal Calculation Failure | Sets due to incomplete or improper module programming procedures. Detects a non-production bootloader file is present or an ABS module with production boot is unlocked |
| ABS U202B:62 | In-Use Application Signing Key: Signal Compare Failure | Sets due to incomplete or improper module programming procedures. Detects non-production software in the ABS module. |
| ABS U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
Possible Sources
- Incomplete programming procedure
- Improper programming procedure
- EBB unit (vehicles with electric boost)
- ABS module (vehicles with vacuum boost)