Abs Guided Routine - Pinpoint Tests C - F
- Pinpoint Tests C: Brake Booster Vacuum Sensor Faults
- Pinpoint Tests Ca: Brake Booster Vacuum Sensor Circuit Faults
- Pinpoint Tests CB: Brake Booster Low Vacuum Fault
- Pinpoint Tests Cc: Aspirator Valve Control Circuit Faults
- Pinpoint Tests CE: Abs Module Communication Concern With HVAC
- Pinpoint Tests Cg: The SELECTABLE Drive Mode Feature Is Inoperative, Cannot Be Disabled Or Enabled
- Pinpoint Tests Ch: The Auto Hold Feature Is Inoperative, Cannot Be Disabled Or Enabled
- Pinpoint Tests CI: The Trail Control Feature Is Inoperative, Cannot Be Enabled Or Disabled
- Pinpoint Tests CJ: Abs Module Communication Concern With The Air Suspension Control Module
- Pinpoint Tests Ck: Abs Module Communication Concern With The IPMB
- Pinpoint Tests Cl: Abs Module Communication Concern With APIM
- Pinpoint Tests Cm: Abs Module Communication Concern With HEV Pcm
- Pinpoint Tests CN: Abs Module Communication Concern With Sima
- Pinpoint Tests Co: Ebb Unit Internal Failure
- Pinpoint Tests Cp: Ebb Brake Booster Motor Faults
- Pinpoint Tests CQ: Driver Door Status Correlation Fault
- Pinpoint Tests Cr: Hydraulic Brake Booster Flow Switch Stuck On Or Off
- Pinpoint Tests Cs: HYDROMAX Brake Booster Motor Faults
- Pinpoint Tests Cu: Hydraulic Brake Booster R Line: Circuit Open
- Pinpoint Tests CV: Abs Module DTC C1A99 - Pressure Sensor
- Pinpoint Tests Cw: Ebb Brake Pedal Switch Faults
- Pinpoint Tests CX: Abs Module In-Use Application Signing Key Error
- Pinpoint Tests Cy: Abs Module Communication Concern With CCM
- Pinpoint Tests CZ: SASM Communication Concern With FCIM
- Pinpoint Tests D: Lost Communication With BCM (Body Control Module)
- Pinpoint Tests DA: SASM Communication Concern With Auxiliary Heater Control Module
- Pinpoint Tests E: The Traction Control System Is Inoperative Or Cannot Be Disabled Using The Message Center
- Pinpoint Tests F: Abs (Anti-Lock Brake System) Battery Voltage Concerns