Instrument Panel: Installation
- To install, reverse the removal procedure.
-
NOTE: Only use the specified material to lubricate the seals.
Lubricate and install new O-ring seals.
Material
: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)
- Fill and bleed the cooling system. Refer to filling and bleeding without a vacuum cooling system filler. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding
-
NOTE: Anytime the parking brake switch electrical connector has been disconnected, the EPB system is deactivated and a DTC is stored in the EPB module. Perform the following step to restore the EPB system and clear the EPB module DTC.
Apply and release the parking brake twice within 5 seconds, pausing with the switch in the NEUTRAL position for approximately one-half second between each apply and release.