LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2021 >> Edge ST-Line, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 472 (Abs Guided Routine) >> Pinpoint Tests >> Pinpoint Tests Z: Module Configuration Concern >> Normal Operation and Fault Conditions
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Normal Operation and Fault Conditions

WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets. 

DTC DESCRIPTION

DTC Description Fault Trigger Conditions
U2100:46 Initial Configuration Not Complete: Calibration/Parameter Memory Failure This DTC is pre-set in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures.
U2100:51 Initial Configuration Not Complete: Not Programmed This DTC is pre-set in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures.
U2100:57 Initial Configuration Not Complete: Invalid/Incompatible Software Component This DTC is pre-set in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures.
U2101:4A Control Module Configuration Incompatible: Incorrect Component Installed This DTC sets due to incomplete or improper module programming procedures.
U2101:55 Control Module Configuration Incompatible: Not Configured This DTC sets due to incomplete or improper module programming procedures.
U2101:56 Control Module Configuration Incompatible: Invalid/Incompatible Configuration This DTC sets due to incomplete or improper module programming procedures.
U2101:57 Control Module Configuration Incompatible: Invalid/Incompatible Software Component This DTC sets due to incomplete or improper module programming procedures.
U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information This DTC sets due to incomplete or improper module programming procedures.
DTC DESCRIPTION

DTC Description Fault Trigger Conditions
U2016:47 Control Module Main Software: Watchdog/Safety Micro-Controller Failure This DTC sets due to incomplete or improper module programming procedures.
U2100:00 Initial Configuration Not Complete: No Sub Type Information Sets due to incomplete or improper module programming procedures.
scientia non olet · About LEMON Manuals