DTC U2100: Initial Configuration Not Complete: Description

WARNING: This page is about a different car, the 2020 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

When a new EPAS gear is installed, the PSCM must be configured with the vehicle information. Configuration is checked during initial PSCM power up (ignition ON) with the voltage supply to the PSCM greater than 6 volts.

DTC U2100:00 (Initial Configuration Not Complete: No Sub Type Information) - This DTC is set if the complete PSCM configuration was not carried out or if the configuration fails.