Pinpoint Tests Purpose

WARNING: This page is about a different car, the 2020 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

To verify the presence of DTC U0422 and identify the correct Service Information for diagnosing the DTC concern.

BU1: CHECK PSCM DTC

Ignition ON, engine running.

Carry out the PSCM self-test.

Is DTC U0422:xx currently present and active in the PSCM?

Yes	No
Go to BU2.	If the PSCM does NOT list DTC U0422 Invalid Data Received from the BCM, DISCONTINUE this test and REFER to the DTC Chart for diagnostic direction.

BU2: CHECK THE VEHICLE BATTERY AND CHARGING SYSTEM VOLTAGE

Ignition ON, engine OFF.
Refer to the Charging System General Information article and carry out Pinpoint Test A: Battery Condition Test (battery state of charge).

Did the battery pass the condition test (battery state of charge)?

Yes	No
Go to BU3.	INSTALL a new 12-volt battery. REFER to the Battery, Mounting and Cables article. Go to BU3.

BU3: RECHECK THE PSCM DTC

Ignition ON, engine OFF.
Clear the PSCM DTCs.
Ignition OFF.
Ignition ON, engine running.

Carry out the PSCM self-test.

Is DTC U0422:xx currently present and active in the PSCM?

Yes	No
DIAGNOSE the BCM concern. REFER to the Multifunction Electronic Modules article.	The concern is not present at this time and may have been set due to a low battery state of charge. The test is complete, no further action is required.