Controller Area Network (Can) Module Communications Network
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| U0001:09 | High Speed CAN Communication Bus: Component Failure | GO to Pinpoint Test AJ |
| U1A01:00 | Communication Link: No Sub Type Information | GO to Pinpoint Test AK |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test AL |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | GO to Pinpoint Test AL |
| U3000:04 | Control Module: System Internal Failure | GO to Pinpoint Test AM |
| U3000:43 | Control Module: Special Memory Failure | GO to Pinpoint Test AM |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test AM |
| U3000:57 | Control Module: Invalid / Incompatible Software Component | GO to Pinpoint Test AN |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AO |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AP |