Body Control Module (BCM): Installation

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
NOTE: Carry out the remaining steps only if installing a new BCM.
NOTE: The PMI (programmable module installation) application in the scan tool will guide you through completing the BCM (body control module) programming and key programming.

Run the PMI on the BCM.
After keys have been programmed as directed by the on screen prompts, and the BCM programming has fully completed (as indicated by a module installation complete or successful message), carry out the PATS Module Initialization using the FDRS Scan Tool PATS Application.
As directed by the scan tool, follow the onscreen prompts to relearn the TPMS sensors. Refer to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .
If equipped with a video rear parking aid (rear mounted only), using a diagnostic scan tool, carry out the LIN New Module Initialization function.
Using a diagnostic scan tool, carry out the BMS Learned Values Reset.
Configure the BCM Programmable Parameters. Refer to: Module Programming .
Using a diagnostic scan tool, carry out the BCM self-test (must include an on-demand self-test) and then repeat the self-test to confirm all DTC have been cleared.
NOTE: This step only applies to vehicles without a stand-alone PAM (parking assist control module).

Using a diagnostic scan tool, complete the PMI process for the PAM following the on-screen instructions. Refer to: Module Configuration - System Operation and Component Description .