Pinpoint Test D: Abs Module Communication Concern With BCM
Normal Operation and Fault Conditions
With the ignition ON, the BCM sends messages to the GWM over the HS-CAN1. The GWM relays these message to the ABS module over the HS-CAN2. If the ABS module does not receive these messages within the allotted time frame or if the messages contain invalid data, the module sets a DTC. This can be due to a BCM failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the BCM, refer to the Network Message Chart .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | This DTC sets when the ABS module does not receive any messages from the BCM within the allowed time. |
| ABS U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | This DTC sets when the ABS module receives messages from the BCM, but the messages contain invalid data. |
Possible Sources
- Network communication concern
- GWM
- BCM