Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P05D3-57 | Driver Mode Select Switch "A" Range/Performance: Invalid/Incompatible Software Component | This DTC sets due to incomplete or improper module programming procedures. The module must be reconfigured using as-built data. |
| U2017:93 | Control Module Software 2: No Operation | This DTC sets if the RSC control logic cannot initialize after stable driving conditions are detected. This is usually due to an incomplete or improper module programming procedures. |
| U2100:46 | Initial Configuration Not Complete: Calibration/Parameter Memory Failure | This DTC is preset in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures. |
| U2100:51 | Initial Configuration Not Complete: Not Programmed | This DTC is preset in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures. |
| U2100:56 | Initial Configuration Not Complete: Invalid/Incompatible Configuration | This DTC sets due to incomplete or improper module programming procedures. |
| U2100:57 | Initial Configuration Not Complete: Invalid/Incompatible Software Component | This DTC is preset in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures. |
| U2101:55 | Control Module Configuration Incompatible: Not Configured | This DTC sets due to incomplete or improper module programming procedures. |
| U2101:56 | Control Module Configuration Incompatible: Invalid/Incompatible Configuration | This DTC sets due to incomplete or improper module programming procedures. |
| U2101:57 | Control Module Configuration Incompatible: Invalid/Incompatible Software Component | This DTC sets due to incomplete or improper module programming procedures. |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | This DTC sets due to incomplete or improper module programming procedures. |
| U2200:83 | Control Module Configuration Memory Corrupt: Value of Signal Protection Calculation Incorrect | This DTC sets due to incomplete or improper module programming procedures. |