Body Control Module C (BCMC): Removal

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

NOTE: If the BCMC (body control module C) did not respond to the diagnostic scan tool, As-Built Data may need to be entered as part of the repair. This step is only necessary if the BCMC (body control module C) is being replaced.

Using a diagnostic scan tool, begin the PMI process for the BCMC following the on-screen instructions.
Disconnect the battery. Refer to: Battery Disconnect and Connect .
Disconnect the PCM electrical connectors. Release the harness retainers from the lower PCM cover to position aside the harnesses.

Courtesy of FORD MOTOR COMPANY
Release the tabs and remove the BCMC access covers.

Courtesy of FORD MOTOR COMPANY
Remove the BCMC wire end connector nuts and remove the wire end connectors.
Torque

: 93 lb.in (10.5 Nm)

Courtesy of FORD MOTOR COMPANY
Remove the BCMC bolts.

Courtesy of FORD MOTOR COMPANY
NOTE: BCMC (body control module C) is shown removed and from underneath to show tab locations.

Release the 4 tabs and position up the BCMC.

Courtesy of FORD MOTOR COMPANY
NOTE: 4 BCMC (body control module C) connectors are shown, some vehicles may be equipped with 5.

Disconnect the connectors an release the wiring harness retainers and remove the BCMC.

Courtesy of FORD MOTOR COMPANY