Pinpoint Test Y: Abs Module Internal Fault Concern
Normal Operation and Fault Conditions
The ABS module carries out self tests during operation, the module also monitors various inputs and compares the values to what is expected. If the values received are out of range, are not what is expected, or if any of the self tests fail, the ABS module sets a DTC.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS C0001:01 | TCS Control Channel "A" Valve 1: General Electrical Failure | Sets when the ABS module detects an internal fault. |
| ABS C0002:01 | TCS Control Channel "A" Valve 2: General Electrical Failure | Sets when the ABS module detects an internal fault. |
| ABS C0003:01 | TCS Control Channel "B" Valve 1: General Electrical Failure | Sets when the ABS module detects an internal fault. |
| ABS C0004:01 | TCS Control Channel "B" Valve 2: General Electrical Failure | Sets when the ABS module detects an internal fault. |
| ABS C1B11:71 | Pressure Control Valve: Actuator Stuck | Sets when the ABS module detects an unwanted opening or closing of the pressure control valve. This is most likely due to an internal failure of the EBB. |
| ABS U3000:00 | Control Module: No Sub Type Information | Sets when the ABS module detects an internal hardware fault. |
| ABS U3000:49 | Control Module: Internal Electronic Failure | Sets when the ABS module detects an internal hardware fault. |
| ABS U3000:4B | Control Module: Over Temperature | Sets when the ABS module detects excessive temperature within the ABS module. |
| ABS U3000:96 | Control Module: Component Internal Failure | Sets when the ABS module detects an internal hardware fault. |
Possible Sources
- Incorrect sensor input
- Stuck valve
- EBB unit (electric boosted vehicles)
- ABS module (vacuum boosted vehicles)