Diagnostic Trouble Code (DTC) Chart
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| BCM | B1554:11 | Wireless Accessory Charger Enable\Disable: Circuit short to ground | GO to Pinpoint Test A |
| BCM | B1554:13 | Wireless Accessory Charger Enable\Disable: Circuit open | GO to Pinpoint Test A |
| WACM | U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test D |
| WACM | U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test F |
| WACM | U0257:00 | Lost Communication With Front Controls / Display Interface Module: No Sub Type Information | GO to Pinpoint Test E |
| WACM | U201A:51 | Control Module Main Calibration Data: Not Programmed | GO to Pinpoint Test H |
| WACM | U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test H |
| WACM | U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | GO to Pinpoint Test H |
| WACM | U3000:41 | Control Module: General Checksum | GO to Pinpoint Test G |
| WACM | U3000:42 | Control Module: General Memory Failure | GO to Pinpoint Test G |
| WACM | U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test G |
| WACM | U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test C |
| WACM | U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test C |