Diagnostic Trouble Code (DTC) Chart
diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Module | DTC | Description | Action |
|---|---|---|---|
| BCM | B11DB:02 | Battery Monitoring Module "A": General Signal Failure | GO to Pinpoint Test F |
| BCM | B11DB:08 | Battery Monitoring Module "A": Bus Signal/Message Failures | GO to Pinpoint Test F |
| BCM | B11DB:09 | Battery Monitoring Module "A": Component Failures | GO to Pinpoint Test F |
| BCM | B11DB:11 | Battery Monitoring Module "A": Circuit Short To Ground | GO to Pinpoint Test F |
| BCM | B11DB:49 | Battery Monitoring Module "A": Internal Electronic Failure | GO to Pinpoint Test I |
| BCM | B11DB:55 | Battery Monitoring Module "A": Not Configured | GO to Pinpoint Test J |
| BCM | B11DB:9A | Battery Monitoring Module "A": Component or System Operating Conditions | GO to Pinpoint Test F |
| BCM | B1489:11 | Battery Monitoring System (BMS) Sensor Power: Circuit Short To Ground | GO to Pinpoint Test F |
| PCM | P0562:00 | System Voltage Low: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P0563:00 | System Voltage High: No Sub Type Information | GO to Pinpoint Test A |
| PCM | P065B:00 | Generator "A" Control Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P065C:00 | Generator "A" Mechanical Performance: No Sub Type Information | GO to Pinpoint Test B |
| PCM | P065C:00 | Generator "A" Mechanical Performance: No Sub Type Information | GO to Pinpoint Test C |
| PCM | P0A3B:00 | Generator "A" Over Temperature: No Sub Type Information | GO to Pinpoint Test K |
| PCM | P0A5A:00 | Generator Current Sensor Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test E |
| PCM | P0A5B:00 | Generator Current Sensor Circuit Low: No Sub Type Information | GO to Pinpoint Test E |
| PCM | P0A5C:00 | Generator Current Sensor Circuit High: No Sub Type Information | GO to Pinpoint Test E |
| PCM | U012D:00 | Lost Communication With Generator "A" Control Module: No Sub Type Information | GO to Pinpoint Test G |
| PCM | U042E:00 | Invalid Data Received From Generator "A" Control Module: No Sub Type Information | GO to Pinpoint Test G |