Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the CCM sends messages to the IPMA over a private CAN. The IPMA then sends these messages to the ABS module, in the EBB unit, over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame, the ABS module sets a DTC. For information on the messages sent to the ABS module by the CCM, refer to the Network Message Chart in Description and Operation of the Anti-Lock Brake System (ABS) and Stability Control article.
PPT R ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U2107:00 | Collision Mitigation By Braking: No Sub Type Information | This DTC sets when the collision deceleration message from the CCM is sent too often or the duration of the message is too long. This is most likely caused by a network communication concern or an internal failure of the CCM. |