Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2019 Ford F-550 Super Duty, 2019 Ford F-450 Super Duty, 2019 Ford F-350 Super Duty, and 2019 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the PCM sends messages to the ABS module through the GWM over the HS-CAN. If the ABS module does not receive these messages within a certain time frame (usually less than 1 second), the ABS module sets DTCs. For information on the messages sent to the ABS module by the PCM, refer to the Network Message Chart in Description and Operation of the Anti-Lock Brake System (ABS) and Stability Control article.
PPT AI ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Setting Conditions |
|---|---|---|
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | This DTC sets if the ABS module does not receive any messages from the PCM. |
| U0401:00 | Invalid Data Received From ECM/PCM "A": No Sub Type Information | This DTC sets in continuous memory if the brake pedal position message, driven wheel torque message or the accelerator pedal position message from the PCM (sent through the GWM) contains invalid information. |
| U0401:02 | Invalid Data Received From ECM/PCM "A": General Signal Failure | This DTC sets if the brake pedal position message, driven wheel torque message or the accelerator pedal position message from the PCM (sent through the GWM) contains invalid information during an auto stop-start event. DTC U3013:16 is also set when U0401:02 sets. |