Possible Causes

M1: CARRY OUT THE SASM MODULE RESET ROUTINE

Ignition OFF.
Allow the adaptive steering system at least 30 minutes to cool down.
Ignition ON, engine OFF.
Using a diagnostic scan tool, carry out the SASM Module Reset routine.
Clear the SECM DTCs.
Ignition OFF.
Start the engine and wait 20 seconds for the SECM to wake up and test the adaptive steering system.
Ignition ON, engine OFF.

Carry out the SECM self-test.

Is the original DTC from the DTC Fault Trigger Conditions table retrieved again?

Yes	No
Go to M2.	The concern is repaired and the system is operating correctly at this time.

M2: VERIFY ALL WIRING CONNECTIONS

Ignition OFF.
Disconnect all SECM electrical connectors.
Using a good light source, inspect all disconnected electrical connectors for the following:
- corrosion - install new connector or terminal and clean the module pins
- damaged or bent pins - install new terminals or pins
- pushed-out pins - install new pins as necessary
- spread terminals - install new terminals as necessary
Are the connectors free of corrosion, damaged pins, bent pins, pushed-out pins and spread terminals?

Yes	No
Go to M3.	REPAIR the connector or terminals. Refer to the Connector Repair Procedures for schematic and connector information.

M3: CHECK FOR CORRECT SECM OPERATION

Connect all SECM electrical connectors. Make sure they seat and latch correctly.
Operate the system and determine if the concern is still present.
Is the concern still present?

Yes	No
INSTALL a new Steering Wheel (SECM) assembly. CHECK OASIS for any applicable service articles: TSBs, GSB, SSM#2 or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new SECM (part of the steering wheel). REFER to Steering Column article.	The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.