| B11DB:02 |
Battery Monitoring Module "A": General Signal Failure |
GO to Pinpoint Test E |
| B11DB:08 |
Battery Monitoring Module "A": Bus Signal / Message Failure |
GO to Pinpoint Test E |
| B11DB:09 |
Battery Monitoring Module "A": Component Failure |
GO to Pinpoint Test E |
| B11DB:11 |
Battery Monitoring Module "A": Circuit Short To Ground |
GO to Pinpoint Test E |
| B11DB:49 |
Battery Monitoring Module "A": Internal Electronic Failure |
CLEAR the diagnostic trouble codes (DTCs). REPEAT the BCM self-test. If DTC B11DB:49 is retrieved, INSTALL new battery monitoring sensor. REFER to: Battery Monitoring Sensor
. |
| B11DB:55 |
Battery Monitoring Module "A": Not Configured |
CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. INSTALL As-Built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. |
| B11DB:9A |
Battery Monitoring Module "A": Component or System Operating Conditions |
GO to Pinpoint Test E |
| B1489:11 |
Battery Monitoring System (BMS) Sensor Power Circuit Short To Ground |
GO to Pinpoint Test E |