Side And Rear Vision DTCS
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to Pinpoint Test D |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery or Open | If the LH or RH BLIS / CTALED is inoperative, GO to Pinpoint Test D If the LH or RH BLIS/ CTALED is always on, GO to Pinpoint Test C |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test G |
| U0101:00 | Lost Communication with TCM: No Sub Type Information | |
| U0146:00 | Lost Communication with Gateway "A": No Sub Type Information | GO to Pinpoint Test H |
| U0401:86 | Invalid Data Received from ECM/PCM A: Signal Invalid | This continuous memory DTC sets when the SODL or SODR receives invalid network data from the PCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the PCM and other modules on the network. If no PCM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
| U0402:86 | Invalid Data Received from TCM: Signal Invalid | This continuous memory DTC sets when the SODL or SODR receives invalid transmission range network data from the PCM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the PCM and other modules on the network. If no PCM Diagnostic Trouble Codes (DTCs) exist, DIAGNOSE the observable symptom. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This continuous memory DTC sets due to incomplete or incorrect PMI procedures. CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, INSTALL as-built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. REFER to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Side Obstacle Detection Control Module (SODCM) . |
| U2300:55 | Central Configuration: Not Configured | This continuous memory DTC sets when the SODL or SODR does not detect the VIN information on the MS-CAN. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in all other modules. |
| U3000:44 | Control Module: Data Memory Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:44 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module (SODCM) . |
| U3000:45 | Control Module: Program Memory Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:45 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module (SODCM) . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:46 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module (SODCM) . |
| U3000:49 | Control Module: Internal Electronic Failure | CLEAR the SODL or SODR Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the continuous memory or on-demand DTC U3000:49 returns, INSTALL a new SODL or SODR. REFER to: Side Obstacle Detection Control Module (SODCM) . |
| U3002:62 | Vehicle Identification Number: Signal Compare Failure | This continuous memory DTC sets when the VIN stored in the SODL or SODR does not match the VIN that is broadcast on the network. CHECK the vehicle service history for recent service actions related to this module. If there have been recent service actions with this module, REPEAT the PMI procedure as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. REFER to: Side Obstacle Detection Control Module (SODCM) . |