Pinpoint Test K: Module Configuration Faults
- Normal Operation and Fault Conditions
A new AWD module saves vehicle identification (VID) block information from the old module during the PMI routine. The AWD module compares the stored values to allowable values stored in the calibration. If the stored value does not match an allowable value, a DTC is stored.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition AWD P0630:00 VIN Not Programmed or Incompatible - ECM/PCM: No Sub Type Information The VIN stored in the AWD module is not a valid VIN for the calibration. AWD P160A:00 Control Module Vehicle Options Reconfiguration Error: No Sub Type Information The VIN, tire circumference, and axle ratio that are stored in the AWD module do not match the allowable values. AWD U2100:00 Initial Configuration Not Complete: No Sub Type Information Sets when the AWD module detects initial configuration not complete. AWD U2101:00 Control Module Configuration Incompatible: No Sub Type Information Sets when the AWD module detects control module configuration incompatible. Possible Sources
- Incomplete PMI procedure on the AWD module
- Improper module replacement
- AWD module
- K1 CARRY OUT THE PMI (PROGRAMMABLE MODULE INSTALLATION) ROUTINE ON THE AWD (ALL-WHEEL DRIVE) MODULE USING AS-BUILT DATA
- Enter the following diagnostic mode: AWD - Programmable Module Installation.
- Enter the following diagnostic mode: Clear and Retest AWD module self-test.
Did the DTC set?
Yes INSTALL a new AWD module. REFER to: All-Wheel Drive (AWD) Module - 1.5L EcoBoost (132kW/180PS) - I3 (Y1)/2.0L EcoBoost (177kW/240PS) - MI4 . REFER to: All-Wheel Drive (AWD) Module - 2.5L Duratec - Hybrid (121kW/164PS) (BG) . No The repair is complete.