| B109F:01 |
Intrusion Sensor Module: General Electrical Failure |
GO to Pinpoint Test B |
| B109F:02 |
Intrusion Sensor Module: General Signal Failure |
GO to Pinpoint Test B |
| B109F:08 |
Intrusion Sensor Module: Bus Signal / Message Failure |
GO to Pinpoint Test B |
| B109F:49 |
Intrusion Sensor Module: Internal Electronic Failure |
INSTALL a new intrusion sensor. |
| B109F:55 |
Intrusion Sensor Module: Not Configured |
Using a diagnostic scan tool, CARRY OUT the LIN New Module Initialization procedure (Toolbox>Electrical>Service Functions>LIN New Module Initialization). |
| B109F:97 |
Intrusion Sensor Module: Component or System Operation Obstructed or Blocked |
GO to Pinpoint Test B |
| B109F:9A |
Intrusion Sensor Module: Component or System Operating Conditions |
GO to Pinpoint Test B |
| B1305:01 |
Hood Switch: General Electrical Failure |
GO to Pinpoint Test F |
| All other Diagnostic Trouble Codes (DTCs) |
- |
REFER to: BODY CONTROL MODULE (BCM) |