LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2024 >> Edge ST >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Electronic Engine Controls - 2.7L ECOBOOST (238KW/324PS) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description

    (418-01A Module Configuration, Description and Operation). Use the General Equipment: Ford Diagnostic Equipment

  3. NOTE: This step is only necessary when installing a new component.

    Using FDRS, carry out the Trusted Real-Time Operation Network (TRON) Module Authentication procedure. SELECT TRON Diagnosis and Repair and follow the on screen instructions. Refer to: Module Programming .

  4. NOTE: This step is only necessary when installing a new component.

    Reprogram the Passive Anti-Theft System (PATS). Refer to: Anti-Theft Key Programming - Scan Tool .

  5. NOTE: This step is only necessary when installing a new component.

    Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

  6. NOTE: This step is only necessary when installing a new component.

    Transmission strategy download procedure should be performed when a new PCM has been installed in the vehicle. Refer to: Transmission Strategy Download .

scientia non olet · About LEMON Manuals