Repair Procedures: Removal
- Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
- Turn the ignition switch OFF and disconnect the negative (-) battery cable.
- Fold the rear seat cushion.
- Remove the service cover (A) of the fuel pump after loosening the screws.
- Disconnect the fuel feed tube quick - connector (A).
- Lift the vehicle.
- Remove the rear-RH wheel, tire and inner wheel house.
- Disconnect the fuel tank extension connector (A), and then remove the wiring harness from the vehicle.
- Remove the center muffler assembly.
(Refer to Engine Mechanical System - "MUFFLER ")
- Remove the propeller shaft assembly.
(Refer to PROPELLER SHAFT Driveshaft and Axle )
- Disconnect the fuel filler hose (A) and leveling hose (B).
- Support the fuel tank with jack (A).
- Remove the fuel tank installation nut (A) and then loosen the fuel tank (B).
- Disconnect the vent hose (A) and then remove the fuel tank.