LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 619 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.
    Fig 1: Placing Insulators On Stabilizer Shaft
    GM793301Courtesy of GENERAL MOTORS CORP.
    2. Fig 2: Insulators & Stabilizer Shaft
    GM793300Courtesy of GENERAL MOTORS CORP.
  2. Install the insulators to the stabilizer shaft.
  3. Install the stabilizer shaft.
  4. Install the clamps over the insulators and the stabilizer shaft.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install insulator clamp bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Support the lower control arms at curb height.
  7. Perform the following procedure before installing the bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345382 (Canadian P/N 10953489).
    8. Fig 3: Link Bolts & Link Assemblies
    GM793299Courtesy of GENERAL MOTORS CORP.
  8. Install the link assemblies.
  9. Install the link bolts.
  10. Install the nuts to the link bolt assemblies.

    Tighten:  Tighten the nut to 14 N.m (10 lb ft).

  11. Ensure that the threads of the link bolt protrude 2 to 4 threads above the link nut.
  12. Install the engine protections shield. Refer to Engine Protection Shield Replacement .
  13. Lower the vehicle.
scientia non olet · About LEMON Manuals