Repair Procedures: Replacement

CAUTION:

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.

Remove the front seat assembly.
(Refer to Front Seat - "FRONT SEAT ASSEMBLY ")
Remove the rear seat assembly.
(Refer to Rear Seat - "REAR SEAT ASSEMBLY ")
Remove the console rear complete & console front complete assembly.
(Refer to Floor Console - "FLOOR CONSOLE ASSEMBLY ")
Remove the front pillar trim.
(Refer to Interior Trim - "FRONT PILLAR TRIM ")
Remove the center pillar upper trim.
(Refer to Interior Trim - "CENTER PILLAR TRIM ")
Remove the rear pillar trim.
(Refer to Interior Trim - "REAR PILLAR TRIM ")
Remove the sunvisor and retainer.
(Refer to Roof Trim - "Sunvisor ")
Remove the assist handle.
(Refer to Roof Trim - "Assist Handle ")
Remove the overhead console lamp.
(Refer to Body Electrical System - "OVERHEAD CONSOLE LAMP ")
Remove the room lamp.
(Refer to Body Electrical System - "ROOM LAMP ")
Remove the ECM mirror cover (A).
Disconnect the ECM mirror connector (B).

Fig 1: Locating ECM Mirror Cover And ECM Mirror Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rain sensor cover (A).
Disconnect the rain sensor connector (B).

Fig 2: Locating Rain Sensor Cover And Rain Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the roof trim main connectors (A).

Fig 3: Locating Roof Trim Main Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Detach the clips, then remove the roof trim assembly (A).

Fig 4: Locating Roof Trim Assembly With Clips
Courtesy of HYUNDAI MOTOR AMERICA
Remove the vanity lamp.
(Refer to Body Electrical System - "ROOM LAMP ")
Remove the hands free mic.
(Refer to Body Electrical System - "HANDS FREE MIC ")
Installation is the reverse of removal.
NOTE:
- Make sure the connector is plugged in properly.
- Replace any damaged clips.