Front Wiper Module
WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The front wiper motor can be removed from the wiper module and is serviced independently from the remainder of the wiper module for this vehicle. See INSTALLATION .
- Position the front wiper module (3) into the cowl plenum as a unit.
- Reconnect the wire harness connector (2) to the connector receptacle for the front wiper motor.
- Position the mount on the inboard end of the wiper module bracket onto the stud within the cowl plenum.
- Loosely install the nut (1) and the two screws (4) that secure the wiper module within the cowl plenum.
- Working from left to right, tighten the two screws and the nut to 6 N.m (55 in. lbs.).
- Reinstall the cowl plenum cover/grille panel over the front wiper module. Refer to INSTALLATION .
- Reinstall both front wiper arms onto the wiper pivots. See INSTALLATION .
- Reconnect the battery negative cable.